Air float deburring attachment
Depending on your computer and network environment the movie may not run smoothly.
If this occurs wait until the gauge below the movie fills to the right before pressing play.
Air float deburring attachment that is most suitable for automation of deburring
This air float deburring attachment makes it possible to remove all deburrs made in the parting line, thick-walled parts, sprue, and ingate required for making one work.

Cover the unmeasured parts in the x-axis and y-axis direction
The air float part (motor spindle attaching part) tilts up to 5°and freely moves 360 degrees in radial direction (multi-float mechanism).

Cover the unmeasured parts in the z-axis direction
The air float part contracts 8mm in the axial direction (axial float mechanism).

Free regulation of the floating power according to the material of work.

Customers can freely regulate the floating power (cutting tool pushing power) by regulating the air pressure to be supplied to the air float part.
The air pressure can be regulated in the range from 0.05 to 0.2MPa.
* Note that the floating power changes depending on the position of the cutting tool being pushed to the works.
* The floating power regulation can be automated by using the electropneumatic regulator.


Free selection of motor spindle
Customers can freely select a commercially available motor spindle and attach it to the air float deburring attachment.

Two kinds of the sizes of motor spindle attaching part are available.
For the air float deburring attachment, two kinds of motor spindle attaching part are available - AF30 that can attach the 30 φ motor spindle and AF40 that can attach the 40 φ motor spindle.
*Note that this product is locked with screws and can be neither disassembled nor repaired.

The air float deburring attachment equipped with the motor spindle are also available.
The air float deburring attachment equipped with the 30φ or 40φ motor spindle is also available.
For details, consult our sales department.